Fitting/Removing The Steering Wheel Arrester; Attaching The Clamp; Universal Quick-Action Clamp - Bosch FWA 4310 Instrucciones De Funcionamiento

en 32 | FWA 43xx / 44xx | Operation
4 .6 Fitting/removing the steering wheel
arrester
The steering wheel arrester fixes the steering wheel in
position and blocks the wheels
1. Place the steering wheel arrester on the seat and
press the plate into the seat.
2. Slide the arms upwards against the steering wheel.
Release the plate so that pressure is exerted on the
3.
steering wheel by way of the seat cushion.
4. Remove in the reverse order of fitting.
Fig. 13: Steering wheel arrester
i
Ensure proper attachment to prevent damage to the
seat and steering wheel. Place a cloth underneath if
necessary.
4 .7

Attaching the clamp

4 .7 .1

Universal quick-action clamp

Fig. 14: Universal quick-action clamp
i
The universal quick-action clamp fits all steel and
aluminum rim sizes between 10" and 21" and is
suitable for all motor vehicle rims without an adapter
hole.
|
1 690 326 001 2008-09-17
!
The clamping method used depends on the type of
rim and the means of attachment. Special plastic-
coated clamping jaws are to be used for high-grade
rims
i
By turning a threaded spindle, the universal quick-
action clamp can quickly be centered from inside to
outside and from outside to inside in the center axis
of the rim and clamped to the rim.
1. The clamping jaws are positioned against the inside/
outside of the rim flange.
2. Pressed outwards or inwards against the rim by way
of the spindle.
Fig. 15: Attachment to the rim flange
!
Check the firmness of the clamping jaws again
following attachment to the tire.
i
Run-out compensation is necessary when using the
universal clamp (Online Help)
Robert Bosch GmbH