Drill And Reamer Attachments; Definitions; Instructions; To Process The Equipment - Stryker SYSTEM G 7305-001-000 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
7305-001-700 Rev-A

Drill and Reamer Attachments

B
A
Retaining Collar – Slide to allow installation
of a cutting tool.
J-Notch – Secures the attachment in the
B
handpiece.

Definitions

The symbols located on the equipment and/or labeling
are defined in this section and/or in the Symbol Definition
Chart. See the Symbol Definition Chart supplied with the
equipment.
Symbol
Definition
General Warning Sign
Forward/Reverse Trigger
(Action is in the direction of the arrow.)
Forward/Reverse Trigger
(Action is in the direction of the arrow.)
F/R 1 min/
Duty Cycle
4 min X 3
(See the Specifications section.)
Lock
Unlock
Direction of Rotation
Alignment Mark
USE ONLY
STRYKER
Use only Stryker power module.
POWER
MODULE
STERILIZE
WITH DOOR
Sterilize with door fully open.
FULLY OPEN
S
Small Diameter
L
Large Diameter
Run
Load
SERIAL
Serial Number
www.stryker.com
A

Instructions

To Process the Equipment

WARNING: Upon initial receipt and before each
use, process the equipment as indicated in the care
instructions manual supplied with the equipment.

To Charge a Power Module

Fully charge the power module before first and every use.
NOTES:
▪ For charging instructions, see the instructions for use
supplied with the battery charger.
▪ For additional information, including safety information,
see the instructions for use supplied with the power
module.
EN
7

Publicidad

Tabla de contenido
loading

Tabla de contenido