Specifications; Handpiece; Attachments; Wire And Pin Collets - Stryker SYSTEM G 7305-001-000 Instrucciones De Uso

EN

Specifications

Handpiece

Model:
Catalog Number:
Dimensions:
Length:
Width:
Height:
Mass:
Nominal Speed:
Drill:
Ream:
Mode of Operation:
Duty Cycle:
Rest Between Cycles:
Applied Part:
Maximum Temperature
of Applied Part:
Power Supply:
Ingress Protection (IP):
Equipment Type:
European Conformity:

Attachments

Wire and Pin Collets

Model:
Catalog Number:
Dimensions:
Length:
Diameter:
Mass:
Gear Ratio:
Ingress Protection (IP):
European Conformity:
14
STRYKER SYSTEM G Rotary Drill
7305-001-000
168.15 mm
83.82 mm
226.10 mm
1.043 kg
825 revolutions per minute
250 revolutions per minute
Non-continuous
1 minute on/4 minutes off, 3 times
4 hours
The handpiece, attachment, and cutting or fixation tool as defined by the manufacturer
Less than 43 °C, as tested to the Product Safety Compliance standards at a maximum ambient
temperature of 30 °C.
Internally Powered
IPX0
Type BF Applied Part
STRYKER SYSTEM G
Wire Collet
7307-001-000
88 mm
26 mm
0.27 kg
1:1
IPX0
STRYKER SYSTEM G
Pin Collet, Small
7307-002-000
88 mm
26 mm
0.27 kg
1:1
7305-001-700 Rev-A
STRYKER SYSTEM G
Pin Collet, Large
7307-003-000
88 mm
26 mm
0.27 kg
1:1
www.stryker.com