To Remove An Attachment; To Remove A Power Module - Stryker SYSTEM G 7305-001-000 Instrucciones De Uso

7305-001-700 Rev-A
2. Set the safety switch to the forward or forward/reverse
mode position.
NOTE: Set the safety switch back to the safe mode
position when the handpiece is idle or when passing the
handpiece to another person.
CAUTION: DO NOT apply excessive pressure or restrict
the motion of the cutting or fixation tool during operation.
An excessive load on the system may cause the power
module to temporarily shut down. If this happens, release
the trigger to resume operation or allow the power module
to cool for 20 to 40 minutes.
3. Pull the triggers to control the variable speed operation
of the handpiece.
NOTE: Typical power module run time is 5 minutes or
longer, depending on surgical procedure and technique.

To Remove an Attachment

1. Push the release lever down and pull the attachment
from the handpiece.
www.stryker.com

To Remove a Power Module

NOTE: Keep the power module as clean as possible
because it cannot be sterilized.
1. Wipe all debris from the external surfaces of the
handpiece.
2. Turn the latch to the unlock position and open the
door.
3. Use the handle to remove the power module from the
handpiece.
EN
13