Logical Level
Inversion
OFF
OFF
Status
• the usability of the measured value in the user program
• the device status (self-diagnosis/system diagnosis)
• additional process information (process alarms)
Please see the full manual for tables listing the codes for the Status byte.
Configuring the user data
Notes:
• To configure STEP 7, use HW-Konfig.
• To configure STEP 5, use COM_PROFIBUS.
The Discrete input function block supplies the content of the OUT parameter.
Diagnosis
In addition to information on the usability of the measured value, Pointek CLS300 can actively
report information on its own status. Please see the full manual for a list of diagnostic
messages.
Remote Operation via PROFIBUS PA
To use PROFIBUS PA, you will need a PC configuration tool: we recommend SIMATIC PDM. You
can download an application guide from the CLS300 product page at:
https://pia.khe.siemens.com/index.asp?Nr=4926. Also see the proprietary operating
instructions or online help for details.
Functions
Open the device menu (top left side of screen) for access to the following functions: Upload
from/Download to Device, Set Address, Master Reset, Write Locking, Sensor Test (via
PROFIBUS PA), and Simulation.
Changing parameter settings
• First launch SIMATIC PDM, connect to Pointek CLS300, and upload data from the device.
• Adjust parameter values in the parameter view field (right side of screen).
• When you have completed the adjustments, open the Device menu, download data to the
device, then save parameter settings offline.
• Go to View – Display to track the effects.
7ML19985QF81
Pointek CLS300 (PROFIBUS PA) – QUICK START MANUAL
Sensor Status
uncovered
covered
Logical Level
= 0 (zero)
= 1
Page EN-17