Displaying Stored Results; Deleting Measurements From The Memory - HoMedics BPW-1005-EU Manual De Instrucciones

7. DISPLAYING STORED RESULTS

a. After measurement, you can review the results in the memory bank by pressing the "MEM" button.
Alternatively, you can press "MEM" button in Clock Mode to display the stored results. If no result is stored,
the LCD will show dashes as picture 7, press the button "MEM" or "START", then the machine will turn off. If
there are results in the memory bank, the LCD will display the amount of the results in the memory bank.
See picture 7-1.
is
center if
b. And then, the most recent result will be displayed with date and time stamp. See picture 7-2. Followed by,
the blood pressure and pulse rate will be shown separately. Irregular heartbeat symbol (if any) will blink.
See picture 7-3 & 7-4. Press "MEM" button again to review the next result.
See picture 7-5. In this way, repeatedly pressing the MEM button displays the
respective results measured previously.
nitor
c. When displaying the stored results, the monitor will turn off automatically after
pulse
1 minute of no operation. You can also press the button "START" to turn off the
ny) will
monitor manually.
ively,

8. DELETING MEASUREMENTS FROM THE MEMORY

When any result is displaying, keeping on pressing button "MEM" for three seconds,
all results in the current memory bank will be deleted after three "beep". LCD will
show picture 8, Press the button "MEM" or "START", the monitor will turn off.
Picture 7 Picture 7-1
Picture 7-3 Picture 7-4
Picture 7-2
Picture 7-5
9 9
Picture 8