Clock And Date Adjustment; Connecting The Cuff To The Monitor; Applying The Cuff - HoMedics BPW-1005-EU Manual De Instrucciones

used
The monitor, the batteries and the cuff, must be disposed of according to local regulations at the end of
their usage.

2. CLOCK AND DATE ADJUSTMENT

suant
a. Once you install the battery or turn off the monitor, it will enter Clock Mode, and LCD will display time and
mful
date by turns. See picture 2 & 2-1.
ency
rence
ular
h
ected.
ons:
e
b. While the monitor is in Clock Mode, pressing both the "START" and "MEM" button simultaneously, a beep
is heard and the month will blink at first. See picture 2-2. Press the button "START" repeatedly, the day,
nnex B
hour and minute will blink in turn. While the number is blinking, press the button "MEM" to increase the
number. Keep on pressing the button "MEM", the number will increase fast.
c. You can turn off the monitor by pressing "START" button when the minute is blinking, then the time and
date is confirmed.
s a
d. The monitor will turn off automatically after 1 minute of no operation, with the time and date unchanged.
d
e. Once you change the batteries, you should readjust the time and date.
e cuff

3. CONNECTING THE CUFF TO THE MONITOR

The cuff is attached to the monitor when it is packaged. Should the cuff become unattached, align the two
plugs and four brackets of the cuff with the plug sockets and bracket sockets of the monitor and press the cuff
to the monitor until the plugs and brackets are securely attached.

4. APPLYING THE CUFF

a. Place the cuff around a bare wrist 1-2cm above the wrist joint on the
palm side of the wrist.
of
b. While seated, place the arm with the cuffed wrist in front of your body
on a desk or table with the palm up. If the cuff is correctly placed, you
lenty of
can read the LCD display.
c. The cuff must be neither too tight nor too loose.
Picture 2 Picture 2-1
7 7
Picture 2-2