Setting the clock
• In standby mode, press and hold the "
• Setting the time: Press the " " button to set the hour time and " " button to set the minute
time.
• Press the "
-SET" button to confirm each setting option.
Using the antenna
Unroll and extend the antenna to improve FM signal reception.
Controlling the sound volume
While listening to the radio, press the "
1. Press the " " button to switch the radio on.
2. Press the " " or " " button to adjust frequency.
3. Press and hold the " " or " " button to automatically tune to the next available FM station.
4. Press the " " button to switch the radio off.
Setting preset stations
You can store up to 10 preset stations.
1. Tune to a station.
2. Press and hold the "MEM/M+" button until "P01" (or the next available preset slot) shows on
the display.
3. Press the " " or " " button to select a preset number (P01-P10).
4. Press the "
- SET" button to confirm. The preset station has been set up.
5. Press the "MEM/M+" button repeatedly while listening to the radio to select a preset station.
Alternatively, press the "MEM/M+" button once and then press the " " or " " button to
select a preset station.
Setting alarms
The radio lets you have 2 alarm settings. To set the alarms:
1. In standby mode, press and hold the "
mode.
2. In the alarm setting mode, press the "
setting options:
Alarm time > Alarm sound source
• Setting alarm time: Press the " " to set the hour time and " " button to set the minute
time.
• Setting alarm sound source: Press the " " or " " button to select the alarm or radio as the
alarm sound source. The corresponding alarm indicator will turn on according to your
selection.
• Note: When the alarm is set to radio mode, the alarm will use the last tuned radio station.
- SET" button to enter the clock setting mode.
" or "
" button to control the volume.
Listening to radio
Using the alarms
" or "
" button to enter the alarm time setting
" or "
" button repeatedly to cycle through the
2
UR106 / English Instruction Manual