Suntec Wellness KLIMATRONIC HEAT SUPREME Manual Del Usuario página 19

positions for the lower wall mounting support. Then remove the heater from the wall mounting support.
STEP X: Drill both holes.
STEP XI: Hammer the 2 remaining anchors into the holes.
STEP XII: Install the heater on the wall mounting support and screw tightly the 2 remaining
screws of the lower wall mounting support.
OPERATION
Please read all the instructions before using this heater.
Please make sure the power switch is on "OFF" position.
1.
2.
Plug the power cord into a suitable electrical outlet. (Rating is not less than 10A)
3.
Please press the main switch to "ON". Press and hold the "MODE" and "SET" buttons for 10 seconds
to reset the programming (this step only needs to be done during the initial start-up for switching on).
4.
Please use the "SET", "+" and "-" buttons to set the current time and day. You can also use these
buttons to set the weekly program for switching the unit on and off, as well as the target temperature.
Example: Programming on Sunday "Sun", switch-on time "ON" 7:30 h, switch-off time "OFF" 10:00 h,
target temperature 20°C
Press the button "MODE" to select the operation mode:
5.
•
Manual mode:
The display shows a hand symbol. The preset target temperature is 22°C.
Please use the "+" and "-" keys to set your desired target temperature to either
5°C (anti-frost function) or 10°C-32°C. If the room temperature is lower than
your target temperature, the heating switches on. If the room temperature is
higher than the target temperature, the heater turns off. Heating continues as soon as the
room temperature is at least 3°C lower than the target temperature.
•
Program mode:
The unit activates the saved week program.
•
Auto mode:
In auto mode, the saved week program is activated in the same way as in
program mode. In addition, the switch-on time is automatically adjusted to the
difference between the room temperature and the target temperature in order
to reach the target temperature more quickly at the set time:
If the room temperature is 5°C lower than the target temperature, the unit switches on 30
minutes before the programmed switch-on time.
If the room temperature from 6°C is lower than the target temperature, the unit switches on 60
min. before the programmed switch-on time.
Anti Frost Function
It will keep the room temperature above "Freezing Point". Please set the temperature to 5°C in manual mode.
This prevents pipe breakage due to ice.
User Advice:
•
If you will be away for several hours, consider reducing the temperature setting.
•
If you have several appliances in one room, do not let them operate simultaneously. Therefore you
will obtain a more homogeneous temperature without increasing your electricity
consumption.
•
When you are airing a room, switch off the appliance.
CLEANING
1.
Before cleaning, turn off the heater, unplug the power cord and allow the heater to cool down.
2.
Do not immerse power cord and plug or heater in water or other liquid. Do not pour water or other
liquid over the heater.