Typical Applications; Sweeping Over Dry Surfaces; Sweeping Over Wet Surfaces; Sweeping Up Large Objects (Sticks, Cans, Etc.) - Kärcher KMR – TRAC Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 103
KMR – TRAC

Typical applications

13
4

Cleaning and care

User Instructions

Sweeping over dry surfaces

Large amounts of dirt with several layers of leaves
Sweep up leaves first of all.
Normal or small amount of dirt
For cleaning main area – lower brush roller
and additionally,
for cleaning up to right-hand edge – lower side brush.
Note: Always select the slowest speed (lever (13) set
to position 1) when working with the side brush.
At regular intervals
Clean off plate filter.
Empty debris container.

Sweeping over wet surfaces

Sweeping procedure is same as for dry surfaces.
At regular intervals
Empty debris container.

Sweeping up large objects (sticks, cans, etc.)

Pull on lever (4) to open coarse-dirt flap.
2
With coarse-dirt flap open, slowly drive over objects to
be picked up.
1

Overcoming obstacles

You can drive over an obstacle up to 3 cm in height
without any problems.
6
A ramp must be used to drive over obstacles greater
than 3 cm in height. Remove debris containers if
required.
Before you commence any cleaning or care tasks,
switch off sweeper.

Cleaning the interior of the sweeper

The interior can be blown clean with compressed air.

Cleaning the exterior of the sweeper

The exterior of the unit can be wiped clean with a damp
cloth. Do not use any aggressive cleaning agents, other-
wise damage could occur to the plastic components.
English
31

Publicidad

Tabla de contenido
loading

Tabla de contenido