Replacing The Plate Filter; Replacing The Brush Roller - Kärcher KMR – TRAC Instrucciones De Servicio

English

Replacing the plate filter

Replacing the brush roller

Brush roller seen from above
direction of travel
38
User Instructions
The plate filter captures the dust that is thrown up by the
brushes.
Replace the filter, if
– dust is expelled by the sweeper and the plate filter is
damaged,
– operating the filter shaker does not provide the
desired results.
Use KÄRCHER Plate Filter (Order no. 5.731-052) only.
Park sweeper and switch off engine.
Open flap covering filter.
Loosen bar on filter shaker (SW 5), and then pull it
out.
Remove hex-socket bolts (SW 5), detach frame and
lift out plate filter.
Insert new plate filter, attach frame and refit hex-
socket bolts.
Position sweeper on a flat surface, and apply parking
brake.
Close fuel supply tap, and allow engine to continue
running until it cuts out by itself.
Lower brush roller.
Remove debris containers.
Detach fine-dust container.
Tilt sweeper backwards until chassis touches floor.
Attention: The sweeper should not be tilted
backwards for longer than 5 minutes (engine oil
could seep into carburettor). Before proceeding,
check that the sweeper is fixed in position and
cannot tilt forward again. If necessary a second
person should hold the sweeper.
Remove right and left hex-socket bolts.
Lift brush roller out downwards.
Fit new sweeping roller; see drawing for correct
alignment.
Continue with assembly in reverse order to removal
procedure.
Check engine oil level before restarting sweeper.
After engine has been started, a small amount of
smoke is normal. This will cease of its own accord.
KMR – TRAC