Sauder Carson Forge 419575 Manual De Instalación página 24

Step 20
Fasten the END MOLDINGS (W) to the LOWER ENDS (C
å
and E). Tighten four HIDDEN CAMS.
Fasten the HINGE MOLDINGS (V) to the LOWER
å
ENDS (C and E). Use four BLACK 1-1/2" FLAT HEAD
SCREWS (101S).
NOTE: Be sure to position the HINGE MOLDINGS exactly
å
as shown in the enlarged diagram below.
W
E
V
Surface with
more holes
Page 24
BLACK 1-1/2" FLAT HEAD SCREW
(4 used in this step)
W
V
C
419575
Maximum
210 degrees
Minimum
190 degrees
101S
Arrow
The END MOLDINGS (W)
should overhang the LOWER
ENDS (C and E) slightly.
www.sauder.com/services