13�3 Operating Instructions; 13�4 Adjusting The Height Of The Cutter; 13�5 Changing The Cutter - Renfert Millo Instrucciones De Uso Originales

13.3 Operating instructions
Sections of the dental arch may break off during trimming.
Wear protective glasses!
EN
The dust created during trimming can be hazardous to health.
Wear a face mask!
Risk of injury to hands!
The cutters of the trimmer are sharp.
Risk of injury!
When working with the tapered coarse cutter on plastic dental arches risk of injury by hooking
into and flying around.
Use the tapered cross-cut cutter for plastic dental arches.
Depending on the pressure applied, sound pressure levels of over 85 db(A) can occur.
Wear ear protection!
Risk of injury by becoming entangled in the unit!
Do not operate with unprotected long hair or loose clothing.
• Control the dental arch on the work table using both hands�
• Always keep hold of the dental arch when it is in contact with the cutter�
• Move the dental arch counter to the rotational direction of the cutter:
- optimal removal
- reduces the risk of the cutter catching�
13.4 Adjusting the height of the cutter
Only the Millo pro (Fig� 11)
Raising the cutter:
• Turn the adjustment wheel to the left�
Lowering the cutter:
• Turn the adjustment wheel to the right�
13.5 Changing the cutter
Risk of injury!
The cutters are sharp. Take great care when changing the cutters.
Risk of injury!
The cutters heat up during trimming. Allow them to cool before changing them.
Always use Renfert cutters.
Changing the cutters:
• Switch off the unit�
• Unplug the unit�
• Allow the cutter to cool�
• Remove the work table (Fig� 8)�
• Remove the protective cap (Fig� 9)�
The protective cap is more easily removed by pressing it together at the flat surfaces of the
clamping ring (Fig. 9).
• Loosen the clamping ring with the Allen key supplied (Fig� 10)�
The Allen key is kept in a holder under the work table.
• Remove the cutter�
• Insert the new cutter fully into the clamping ring�
• Tighten the clamping ring with the Allen key (Fig� 10)�
Ensure that the clamping ring has been adequately tightened.
• Replace the protective cap�
• Place the Allen key in the holder�
• Replace the work table�
- 6 -