Cleaning / Servicing; 14�1 Cleaning The Housing; 14�2 Cleaning The Work Table; 14�3 Changing The Fuse - Renfert Millo Instrucciones De Uso Originales

14 Cleaning / Servicing

Switch off and unplug the unit before cleaning or servicing it.
14.1 Cleaning the housing
Never clean the unit under running water or immerse it in water.
Do not steam clean the unit.
Risk of injury!
Cover sharp cutters if necessary.
Do NOT use cleaning agents that are caustic or abrasive or that contain solvent.
• Switch off the unit�
• Unplug the unit�
• Wipe the housing with a damp cloth�
• Remove the work table (Fig� 8)�
• Vacuum out the dust receptacle and wipe with a damp cloth�
• Dry the unit with a soft, clean cloth�
14.2 Cleaning the work table
• Remove the work table (Fig� 8)�
• Clean the work table, e�g� steam clean�
• Dry the work table and replace it on the unit�
14.3 Changing the fuse
14.3.1 Millo
Before replacing the fuse, disconnect the unit from the mains power supply by unplugging the
power cord from the wall outlet.
Never use fuses with a higher rating.
• Unplug the unit�
• Place the unit on its side�
• Open the fuse holder (G, Fig� 5) and change the fuse�
14.3.2 Millo pro
• Unplug the unit�
• Press in the safety cut-out (F, Fig� 2) on the side of the unit�

15 Replacement parts

You can find components subject to wear and the spare parts on the spare part
list in the internet at www.renfert.com/p918�
Enter the following item number: 18040000 / 18050000
The components excluded from the warranty (such as consumables or parts sub-
ject to wear and tear) are marked on the spare part list�
Serial number and date of manufacturing are shown on the type plate of the unit�

16 Repair

Repairs should only be carried out by qualified personnel.
Repairs to the electrical equipment, which are not specified in these operating instructions, should only be
carried out by an electrician�
- 7 -
EN