Wiring - SOMFY Sonesse 30 RTS Manual De Usuario

Sonesse 30 RTS
References
1870197
1870198
1870259

2.3.Wiring

WARNING
To ensure electrical safety, this Class III drive must be powered by a «SELV»
voltage source (Safety Extra Low Voltage).
PRECAUTION
• Cables routed through a metal wall must be protected and insulated by
sleeving or sheathing.
• Secure the cables to prevent any contact with moving parts.
• If the drive is used outdoors and if the power supply cable is of the H05-VVF
type, run the cable in a UV-resistant duct, e.g. trunking.
• The drive cable cannot be removed. If it is damaged, return the drive to the
After-Sales department.
CAUTION
• Leave the drive power supply cable accessible: the product must be easily
replaceable.
• Always make a loop in the power supply cable to prevent water from
entering the drive.
CAUTION
• The product is intended for being supplied by Class II output of an external
power supply.
• Do not use an extension cord. If the power supply cord is too short, have a
qualified electrician install an outlet near the motorised product.
Connect the drive to the power supply:
▪ Black wire: -
▪ Red wire: +
©
Copyright 2020 SOMFY ACTIVITES SA. All rights reserved.
Designations
15 motors / Somfy Control Distribution panel
20 motors / Somfy Control Distribution panel
Somfy Power Panel
EN
9