Troubleshooting; Safety Notices; Error Codes; Causes And Rectification Of Faults - CASO DESIGN SteamMaster E 56 Manual De Instrucciones

15 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

15.1 Safety notices

► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

15.2 Error codes

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Display
ER1
ER2
ER3
ER4
ER5
ER6
► If error messages continue to appear after an extended waiting period and restarting
the device, then the device will need to be sent to Customer Service to be inspected.

15.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
► Please clean the device before sending it to customer service.
Attention
Description
Overheating protection
Temperature relay
malfunction
Sensor malfunction
Please note
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Incorrectly selected time or
power level
Please note
Solution
Overheating protection is reset
after the device has cooled down
Function test necessary. Contact
customer service
Contact customer service
Close device door
Plug in mains plug!
Activate fuse
Re-set time and power level
Repeat process
Action
64