Kit Assembly - Metra 99-7807 Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Affix the (2) factory clips to the radio
housing. (Figure A)
2. Mount the climate switches to the
radio housing using (6) of the #8 x
1/2" screws on the upper and outside
mounts. Do not install the screws on
the bottom mounts shared by the
radio brackets until installing the radio/
bracket assembly. (Figure A)
3. Attach the pocket to the brackets with
the (4) #8 x 3/8" Phillips pan-head
screws supplied. (Figure B)
6

KIT ASSEMBLY

(Figure A)
(Figure B)
4. Slide the radio into the brackets and
secure with screws provided with the
aftermarket radio. (Figure C)
5. Mount the radio assembly to the radio
housing by installing (4) of the supplied
#8 x 1/2" screws to the shared radio
brackets. (Figure D)
6. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and AXXESS.
7. Clip the new radio assembly into the
dash and reassemble dash in reverse
order of disassembly.
(Figure C)
(Figure D)
|
386.257.1187 MetraOnline.com