Dismantling And Disposal - Comet C610H Manual De Instrucciones

cauTiOn
• The data shown on the chart are approximate. More frequent jobs may be necessary in case of
particularly heavy-duty use.
Only qualified persons must be allowed to dismantle the motor pump and this operation must be
performed in compliance with the laws applicable in the country where the machine in which it is
integrated has been installed.
m
WaRninG
• Before scrapping the motor pump make sure there is no pressurised oil in the hydraulic motor.
m
WaRninG
• Also follow the instructions contained in the manual of the machine in which the motor pump
is integrated.
• Before doing any jobs, perform the operations described in the "STOP" paragraph.
In the event of not being able to restore the correct operation of the motor pump with the aid of the
information contained on the following table, contact a Skilled Technician.
PROBlEMS
The pump does not prime.
The pump fails to reach max
flow rate.
Irregular pressure and flow rate
(pulsating).
Too much noise.
m
WaRninG
• This part of the manual is dedicated to Skilled TechnicianS and is not intended for users of the
machine in which the motor pump is integrated.
m
WaRninG
• During unpacking, always wear gloves and protective eyewear, to prevent injuring hands and eyes.
• The packaging elements (plastic bags, staples, etc.) must not be left within reach of children as they
represent potential hazard sources.
26

DiSManTlinG anD DiSPOSal

TROuBlEShOOTinG
cauSES
Suction of air.
Air trapped in the pump.
Rotation speed insufficient.
Suction circuit blockages.
Air suction.
The motor pump has not completed
priming.
Suction circuit blockages.
Water supply temperature too high.
PaRT TWO
(for SkillED TEchnicianS only)
unPackinG
REMEDiES
Check the integrity of the suction circuit.
Check the condition of the air bleeder circuit.
Check the condition of the hydraulic circuit.
Verificare lo stato del circuito di aspirazione.
Check the integrity of the suction circuit.
Prime the pump according to the indications of
the "OPERATION" paragraph.
Check the condition of the suction circuit.
Keep to the temperatures indicated in the
"SPECIFICATIONS AND TECHNICAL DATA"
paragraph.