Kit Preparation - Metra 99-7342 Instrucciones De Instalación

From the factory radio trim panel:
1. 2011-2013: Unclip and remove the
hazard switch. (Figure A)
2. 2014 with auto climate controls:
Remove the (2) Phillips screws securing
the thermistor.
3. Remove the (4) Phillips screws securing
the climate control panel. (Figure A)
Note: On the top of the climate control
panel there will be (2) small plastic
locater pins. These must be cut off to fit
properly into the kit.
4. Remove the (4) Phillips screws securing
the clock display. (Figure A)
5. Remove the (4) Phillips screws securing
each vent, and then unclip and remove.
(Figure A)
Continue to the next page

KIT PREPARATION

(Figure A)
3
REV. 5/4/2018 INST99-7342