Mowing Tips - Worx WG783E Traducción De Las Instrucciones Originales

Ocultar thumbs Ver también para WG783E:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
2. GRASS BAG FILLING INDICATOR (See
G)
To remind you immediately to empty when
the grass bag is full, the mower provides
an indicator on the top of bag to show the
collection status. And you can follow as
below:
Empty status: flap float (a)
Fully status: flap fall down (b)
3. REAR DISCHARGE (See H)
The mower provides a rear discharge function,
so that you can mower without bag collection.
The debris will be discharged from the rear
chute.
4. WORK MODE DIAL (See I)
Status1: QUIET mode
Select QUIET mode when mowing in everyday
conditions, removing approximately 20mm of
grass at a time.
Status2: TURBO mode
14
Set the dial to TURBO mode when cutting
dense or overgrown grass.
5. BATTERY STATUS LED'S (See J)
NOTE: The Status LED's will indicate the
battery condition when the button on the
battery is pressed.
The LED's constantly senses and displays the
battery condition as follows:
Press the button "POWERTEST" , the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is depleted.
Before using your new mower for the first
time, it is recommended that the unit be
charged overnight to ensure that the battery is
fully charged.
Cordless lawn mower
) are illuminated, the
) is illuminated,
IMPORTANT
When only one light is illuminated,
your battery is overly discharged, even
though the mower may still be capable
of cutting grass. Continuing to operate
your lawnmower with the battery in this
discharged condition may reduce the life
and performance of your battery.
6. ADJUSTING THE CUTTING HEIGHT
(See K)
WARNING: Before adjusting the mower
height, wait for the mower to completely
stop. Mower blades continue to rotate after
the machine is switched off and a rotating
blade can cause injury. Wait until all machine
components have completely stopped before
touching them.
Before your first cut, adjust the mower cutting
depth to the desired position. The lawnmower
can be set to 3 cutting heights between 20mm
and 60mm.
Grip one wheel and pull it out of the groove
and reposition it in the required height. ALL
other wheels should be positioned at the
same height.

7. MOWING TIPS

NOTE: Always inspect area where mower
is to be used and remove all stones,
sticks, wire, metal and other debris
which might be thrown by the rotating
blade.
1)
Mow across the face of slopes, never
up-and-down. Exercise extreme caution
when changing direction on slopes.
Do not mow excessively steep slopes.
Always maintain good footing.
2)
Release switch lever to turn mower "OFF"
when crossing any graveled area (stones
can be thrown by the blade).
3)
Set mower at highest cutting height when
mowing in rough ground or in tall weeds.
Removing too much grass at one time
can cause circuit breaker to trip, which
stops mower.
4)
If a grass collection bag is used during
the fast growing season, the grass may
tend to clog up at the discharge opening.
Release switch lever to turn mower "OFF" .
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido