Fein BLK 1.6 Manual De Instrucciones página 11

BLK 1.6 - Buch Seite 11 Dienstag, 9. September 2003 2:21 14
BLK 1.6
Maintenance and repairs.
!
Risk of injury
Service, testing and repairs may only be car-
ried out by electrical engineers in conformity
with the regulations valid in the respective
country.
Maintenance and repairs.
We recommend our customer service
department (repair centre), FEIN author-
ized service centres and agencies.
Addresses can be found at the end of
these operating instructions and in the
enclosed safety instructions.
Please hand these operating instructions
to the repair centre. An overview of spare
parts can be found at the end of these
operating instructions.
Upon request a repair manual is sent to
the electrical engineers.
Only use original FEIN spare parts.
Spare parts.
The overview of spare parts is at the end
of these operating instructions. Quoting
the parts no. (1), order no. (2) as well as
the number of spare parts (3) facilitates
the ordering procedure.
Accessories.
Illustrations and order numbers can be
found at the end of these instructions.
Description of the accessories:
A Punch.
B Die.
C Set (punch and die).
D Die holder for sheet with trapezoidal
corrugations and corrugated sheet.
E Die holder for profiled and corrugated
sheet.
F Profile Set 160.
G Punch for Profile Set.
H Die for Profile Set.
I Wear plate for Profile Set.
J Profile Set with set consisting of punch,
die, wear plate, 4 Torx screws and
1 screwdriver.
K Cutting paste.
L Metal carry case
(390 x 240 x 110 mm).
Guarantee.
All the FEIN electric power tools are
tested carefully and are subject to the
stringent requirements of the quality con-
trol at FEIN.
In addition to the legal warranty we also
provide the FEIN manufacturer's guaran-
tee. For further details on this, please con-
tact your specialist dealer, your national
FEIN representative, or the FEIN cus-
tomer service centre.
Damage due to improper handling, over-
loading or normal wear are generally not
covered by the guarantee.
EN
11