Fein BLK 1.6 Manual De Instrucciones página 10

BLK 1.6 - Buch Seite 10 Dienstag, 9. September 2003 2:21 14
EN
Adjusting the cutting direction (3).
Loosen the union nut by approx. 3 rev-
olutions.
Pull the die holder downwards.
Rotate the die holder in the cutting
direction, push up and notch it into the
groove.
Tighten the union nut.
Changing the punch (5).
!
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
Do not regrind the punch and dies. If
increased feed is required to guide the
power tool or if no-load strokes or exces-
sive burr formation occur, the cutting
tools are blunt.
For an optimum cut, change the die and
the punch at the same time.
Loosen the union nut.
Remove the die holder.
Change the punch.
Re-fit the die holder again.
Tighten the union nut.
Changing the die (6).
!
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
For an optimum cut, change the die and
the punch at the same time.
Unscrew the screw (a).
Press out and change the die.
Tighten the screw (a).
10
Assembling the profile set (7).
!
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
Ideal for treating deep-profiled trapezoi-
dal sheets.
Loosen the union nut (7a) and remove
die holder and punch.
Pull the punch extension upwards a lit-
tle out of the profile set and insert it
from the side into the groove.
Mount the profile set.
Tighten the union nut (7a).
For changing the punch pull it out com-
pletely, together with the punch exten-
sion.
Cleaning and care.
!
Risk of injury
by switching the tool ON unintentionally.
Before cleaning, pull out the mains plug.
Carry out the following once a week, or
more often if the power tool is used more
frequently:
Clean the venting openings.
Blow out the motor space from outside
with dry compressed air.
Grease the gliding surfaces between the
punch and the die carrier:
Tube with 85 g – Reference number
3 21 60 003 19 8.
BLK 1.6