Flash Exposure Bracketing (Feb); Feb Setting Surrounded By Exposure Value (Effective For Canon Cameras Only) - Rollei 58 Instrucciones

Flash exposure bracketing (FEB)

By using FEB the flash exposure will be automatically changed, which helps in
conditions of invariable background exposure . You can take three flash shots while
automatically changing the flash output according to 1/3 to plus or minus .
After the FEB is done, the flash will go back to the standard settings that have been
used before . (This can be turned off in the custom settings .)
For using FEB set your camera into the mode "single shot" and ensure that the flash
is ready . Connect the Canon camera and set on the flash exposure value surrounded
exposure .
If a Nikon camera is connected the flash exposure information will not be shown of
the flash . You need to refer to the camera set .
FEB Setting Surrounded by Exposure Value
(effective for Canon cameras only)
Press the "Parameter Settings Button" to enter the setting by the current exposure
value .
1 . The exposure value can be adjusted by the dial .
Rotate it clockwise to increase or counterclock-
wise to decrease the exposure value .
2 . The exposure value has a range of 0 to 3 .0 . The
values are: 0 1 1 .3 1 .7 2 .0 0 .3 0 .7 2 .3 2 .7 3 .0
0 0.3 0.7 1.0 1.3 1.7 2.0 2.3
61
2.7 3.0