Manual Wireless Master Unit (M, Manual, Master, Canon) - Rollei 58 Instrucciones

Manual Wireless MASTER Unit
74
(M, Manual, MASTER, Canon)
Press the [Flash mode select button] to set the MASTER light as manual mode on
the MASTER unit . You can set up each slave unit in different flash light ratios . Using
the MASTER unit to finish all settings (SLAVE unit and MASTER unit is the same) .
1 . Press the [Parameter setting button] for a long
time to set up the Canon MASTER unit Ratio .
2 . Press down the [Flash mode select button] to
set up M mode .
3 . Press down the [Wireless Parameter select
button] so often until RATIO twinkles .
4 . Select the flash light ratio. Rotate the dial to set the flash light ratio:
<RATIO>, <RATIO A: B> or <RATIO A: B: C> . Select the flash light ratio
<RATIO> . This means three SLAVE units will take the same mode and power
output with the MASTER . Press M mode to set the power output : Select the
flash light ratio <RATIO A: B> . This means group A/B will flash and the power
output of the flashes in group A/B will be adjusted on the single flashes . Select
the flash light ration <RATIO A: B: C> . This means three groups are all on and
the power output can be adjusted on all single flashes .
5 . Set the flash output <RATIO A:B> or <RATIO A:B:C>
Press the [Parameter setting button] until SLAVE account A and group A power
twinkles . Rotate the dial to adjust group A power .
Press the [Parameter setting button] until SLAVE account B and group B power
twinkles . Rotate the dial to adjust group B power .
Press the [Parameter setting button] until SLAVE account C and group C power
twinkles . Rotate dial to adjust group C power .
ENGLISH