How To Connect The Open-Collector Inputs Of The Controller; How To Connect The Open-Collector Inputs Of The Controller - Agilent Technologies Turbo-V 1K-GRetrofit Manual De Instrucciones

17 Technical Information

How to Connect the Open-Collector Inputs of the Controller

How to Connect the Open-Collector Inputs of the
Controller
Here below there are the typical connections of the open collector
input of Turbo-V 1K-G Retrofit to an external system. Two cases are
considered:
1. the customer supplies the 24 Vdc
2. the customer does not supply the 24 Vdc
Please note that on the connector a 24 Vdc, 60 mA voltage, a
GROUND signal and the open collector pin are available.
Figure 15
254/294
Case 1
Turbo-V 1K-G Retrofit User Manual / 87-900-996-01 (B)