Service Information - Stanley STEL345 Manual De Instrucciones

shown in Fig.F. The shoe sleeve will click securely onto
the rear of the shoe.
To remove shoe sleeve, grasp the sleeve from the
bottom at the two rear tabs and pull down and away from
the shoe.
HINTS FOR OPTIMUM USE
Sawing laminates
As the saw blade cuts on the upward stroke, splintering
may occur on the surface closest to the shoe plate.
f Use a fine-tooth sae blade.
f Saw from the back surface of the workpiece.
f To minimize splintering, clamp a piece of scrap wood
or hardboard to both sides of the workpiece and saw
through this sandwich.
Sawing metal
f Be aware that sawing metal takes much more time
than sawing wood.
f Use a saw blade suitable for sawing metal.
f When cutting thin metal, clamp a piece of scrap wood
to the back surface of the workpiece and cut through
this sandwich.
f Spread a film of oil along the intended lineof cut
for easier operation and longer blade life. For cutting
aluminum, kerosene is preferred.
RIP / CIRCLE CUTTING (FIG. G AND H)
Ripping and circle cutting without a pencil line are easily
done with the rip fence / circle guide (noy included -
available at extra cost)
Using the screw supplied with the accesory guide, position
as shown in Fig. G and thread the screw into the shoe to
clamp the fence securely.
When ripping, position as shown in Fig G. and slide the rip
fence under the screw from either side of the saw. Set the
cross bar (10) at desired distance from blade and tighten
screw. For ripping, the cross bar should be down and
against the straight edge of the workpiece as shown.
When circle cutting, adjust rip fence so that distance from
balde to hole in fence arm (11) is at the desired radius and
tighten screw. Place saw so that hole in fence arm is over
center of circle to be cut (drill hole for blade or cut inward
from edge of material to get blade into position). When
saw is properly positioned, drive a small nail through hole
in fence arm. Using rip fence as a pivot arm, begin cutting
circle. For circle cutting, the cross bar should be up, as
shown in Fig. H.
MAINTENANCE
Your Stanley power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Countinuous satisfactory operation depends upon proper
tool care and regular cleaning.
f Regulatly clean the ventilation slots in your tool using
a soft brush or dry cloth.
f Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Never let any liquid get inside the tool and never
immerse any part of the tool into liquid
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.

SERVICE INFORMATION

Black & Decker offers a full network of company-owned and
authorized service locations. All Black & Decker Service
Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service.
For more information about our authorized service centers
and if you need technical advice, repair, or genuine factory
replacement parts, contact the Black & Decker location
nearest you, or visit us at www.BlackandDecker-la.com
ENGLISH • 11