Mounting The Bar And Chain (Quick Chain Tensioner) - Stihl MS 260 Manual De Instrucciones

Engfish / USA
Mounting the Bar and Chain
(Quick chain tensioner)
os
• Disengage the chain brake: Pull
hand guard (6) toward front handle.
\
/_k Wear work gloves to protect your
hands from the sharp cutters.
• Fit the chain - start at the bar nose.
Fit the guide bar over the studs (7) -
cutting edges on top of bar must
point to right - and engage the
peg of the tensioner slide in locating
hole (8) -- place the chain over
sprocket (9) at the same time.
• Now turn tensioning screw (10)
clockwise until there is very little
chain sag on the underside of the
bar -- and the drive link tangs are
located in the bar groove.
• Refit the sprocket cover-
and screw on the nuts only finger-
tight.
• Go to"Tensioning the Saw Chain".
• Pull out the hinged clip (1) so that it
snaps into position.
• Turn the wingnut (2) counterclock-
wise until it hangs loose in the
sprocket cover (3).
• Remove the sprocket cover.
MS 260 27