Stop The Engine - Husqvarna Gardol G125-85F Manual De Instrucciones

Starting can take place independent of which gear is
engaged.
N
Lift and pull the lever backwards to reverse.
R
CAUTION! Gear changes between forward gears must not
be made while the machine is moving.
The engine must be disengaged during each gear change.
Stop the machine before changing between forward and
reverse gears, otherwise this may result in damage to the
gearbox.
Never use force to engage a gear. If a gear does not engage
immediately, release the clutch pedal and press it down
again. Now try to engage the gear again.
2 Select the required cutting height (1-5) using the cutting
height lever.
IMPORTANT!
Never use position S when mowing. Position S is the
service position.
3 Lower the cutting unit.
126 –
English
Driving
4 Start the blades by first releasing the lever and then
moving it forward.
CAUTION!
The life span of the drive belts is increased significantly if
the engine runs at a low speed when the blades are
engaged. Therefore apply full throttle first when the cutting
unit has been moved to the mowing position.

Stop the engine

Always park the machine on a level surface with the engine
OFF. Avoid idling the engine for long periods, as there is a risk
of carbon build-up on the spark plugs.
1 Disengaging the blades.
2 Lift up the cutting deck by stepping on the lifting pedal and
pressing in the lock button.
3 Pull back the throttle and move the gear shift lever to "N"
– neutral position. Turn the ignition key to the "STOP".
When the ride-on mower is at a standstill, engage the parking
brake.
N