To Get A Good Cutting Result; To Stop The Engine; To Apply And Release The Parking Brake - Husqvarna R 316TX Manual De Usuario

6. Press the lock button on the lift lever for the cutting
deck and lower it to mow position.

To stop the engine

1. Pull the lift lever for the cutting deck rearward to its
locked position to lift up the cutting deck. The blades
stop to rotate.
2. Turn the ignition key to the STOP position.
3. When the product stops, apply the parking brake.

To apply and release the parking brake

1. Press the parking brake pedal down (1).
2. Press and hold the lock button (2).
1
3. Keep the button pressed and release the parking
brake pedal.
18
2
4. To release the parking brake, press the parking
brake pedal again.

To get a good cutting result

• For best performance, do maintenance on the
product regularly as given in the maintenance
Maintenance schedule on page
schedule. Refer to
19 .
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, refer to
page 35 ). Move the product forward at low speed. If
the grass is not too high and thick, you can get a
good cutting result also at a higher speed.
• Cut the grass in an irregular pattern.
• To get the best cutting result, cut the grass
frequently and use the BioClip function.
To attach load to the engine cover
The product has rails and rail brackets on the engine
cover to attach load.
1. Adjust the rail brackets to fit the load.
a) Loosen the screw and move the rail bracket
forward or rearward on the rail.
b) Tighten the screw.
2. Put a strap through the hole in the rail bracket (A).
A
Technical data on
B
844 - 009 - 25.11.2021