Gastrodomus GRANISMART 3 Manual Del Usuario página 79

6.7. Starting the Granita Maker 2/3 (Electronic thermostat)
Switch (A) in position "I": Machine powered.
Switch (B) in position "I": Mixers operating.
To make SLUSH DRINKS (GRANITA):
Deviators (D) in position "I": Refrigerator system operating (slush drinks - granita).
To make COLD DRINKS:
Deviators (D) in position "II": Refrigerator system operating (cold drinks).
To disable the FRIDGE (mixing only):
Deviators (D) in position "0":Refrigerator system off (mixing only).
2 TANKS
C
A
D
B
Fig.28
ALARMS
In case of probe failure, the display will show the following alarm messages:
"A1": Tank 1 probe disconnected
"A2": Tank 1 probe short circuit
"A3": Tank 2 probe disconnected
"A4": Tank 2 probe short circuit
"A5": Tank 3 probe disconnected
"A6": Tank 3 probe short circuit
During operation, the electronic thermostat shows the temperature of the prod-
uct in the tanks, cyclically showing the temperature of the product fi rst in one
tank and then in the other, every 3 seconds.
To see which tank is referred to with the temperature reading, it is necessary to
check which decimal point is being shown.
SL320000819 Ed.12 - 07-2013
3 TANKS
C
D
A
B
D
B
If the decimal point viewed is on the left, the temperature reading refers to the
tank 1 (see Fig.2 Page 5).
Fig.29
If the decimal point viewed is in the centre, the temperature reading refers to the
tank 2 (see Fig.2, Page 5).
Fig.30
D If the decimal point viewed is on the right, the temperature reading refers to the
tank 3 (see Fig.2, Page 5).
B
D
B
Fig.31
Note: If while using machine, the electronic thermostat should
switch off suddenly, to start it again press the
electronic thermostat should not switch on again, switch off the
machine and contact your nearest assistance centre.
Important: While using the machine, the electronic thermostat
must always be on so as to show the temperature of the product
in the tanks.
2 TANKS
3 TANKS
- 13_EN -
. key. If the