Sanitizing The Evaporator; Cleaning The Drip Tray - Gastrodomus GRANISMART 3 Manual Del Usuario

Press the bowl downward until it engages the surface as shown in the fi gure.
Fig.65
Follow these instructions to refi t the tap:
1 adequately lubricate the plug (X) and OR (Y) using the Vaseline supplied;
2 introduce the tap spring and body from the lower part of the tap;
3 introduce the lever and fi x it in its seat while keeping the tap body pressed
upwards;
4 introduce the pin (F) without moving the tap lever.
Fig.66
X
Note: Correctly install the components as shown in the fi gure.
Note: failure to lubricate the plug or OR may cause product to
leak from the tap.
(for model with lighted lid only): Connect the lid by inserting the plug into
the machine outlet.
SL320000819 Ed.12 - 07-2013
Before starting up the machine, you must sanitize the evaporator.
Proceed as follows:
1 prepare the sanitizing solution in a suitable container (following the direc-
2 pour the sanitizing solution into the bowl;
3 allow time for the sanitizing solution to act (see directions on product pack-
4 empty the tank of sanitizing solution by opening the tap.
Then thoroughly rinse the bowl and evaporator to eliminate residues of sanitiz-
ing solution.
The drip tray should be emptied and cleaned daily.
F
Holding the drainage hose fi rmly, lift the tray with the grid on top of it and pull
it out.
Y
Wash the tray and grid separately with lukewarm water.
Dry all of the components.
Reposition the grid on top of the tray.
Position the drainage hose in the opening provided.
Fit the tray back in place and press down to secure it to the machine.

7.6. Sanitizing the evaporator

tions provided on the package of the sanitizing product)
age).
Warning: the bowl must be rinsed of sanitizing solution as
directed on the package of the sanitizing product and in ac-
cordance with the hygiene regulations currently in force in the
user's country.

7.7. Cleaning the drip tray

Note: all of the drip trays present in the machine should be
cleaned.
Fig.67
- 21_EN -