Sony ZS-D5 Manual De Instrucciones página 25

Note
When "--" is displayed
as the tape length, the
total recording time of
the programed tracks
exceeds 98 minutes.
Start from step 1 again.
Tips
• If you made a mistake,
press CANCEL. The
track programed last
will be cleared. Re-
program it.
• To check the order of
tracks, press
PROGRAM•AUTO
PRESET•CHECK in
stop mode until
"CHECK" appears in
the display. Press
or + to display
=
the track number in the
programmed order.
• To check the total
recording time on the
front side and the
reverse side:
Press DISPLAY
ENTER MEMORY
before starting
recording. Each time
you press the button,
the display changes as
follows: "total
recording time on the
front side" n "total
recording time on the
reverse side" n "total
track number and the
tape length you need
to record the whole
CD.
3
Press = or +
program, and press DISPLAY ENTER MEMORY.
The total number of programed tracks and the
minimum tape length (unit: 2 minutes, up to 98
minutes) you need to record the programed tracks
appear in the display.
4
Repeat step 3.
5
To change the recording time, press DISPLAY
ENTER MEMORY. If you do not change the
recording time, skip to step 7.
Tape length flashes.
6
Press = or +
and press DISPLAY ENTER MEMORY.
7
Insert a blank tape into the tape compartment.
8
Press r/P and then ( .
Recording will start on the front side automatically.
The tracks are recorded in the programed order.
to select the track you want to
to change the recording time
The Tape Player
25 EN