Troubleshooting - Krups BeerTender VB31 Manual De Instrucciones

English

TROUBLESHOOTING

Problem
The appliance does not
come on.
The upper part of the
dispensing head is not
properly positioned.
No beer is being
dispensed.
You cannot close
the upper part of the
dispensing head.
14
Possible causes
The appliance is not
connected to the mains
power supply.
The Beertender Keg
®
tap has been activated
by hand.
The Beertender Keg
®
tap or tube is not
inserted correctly.
The Beertender Keg
®
is empty.
There is no keg inside
the Beertender
®
appliance.
The Beertender
®
appliance tap handle is
not correctly installed/
positioned.
The upper part of the
dispensing head was
improperly positioned.
Remedies
Connect the appliance
to the power supply.
Put the Beertender
Keg tap back in its
original position.
Remove the
Beertender Keg tap
®
from the appliance and
fit it again following
section: Using the
Beertender .
®
Replace the
Beertender Keg with a
®
new one.
Install a keg inside the
Beertender appliance.
®
Install/position the
tap cover correctly.
Properly position
the upper part of the
dispensing head.
®