Important - JVC HR-S8006UM Manual De Instrucciones

1
4
7
NUMBER "8"
STOP+/–
PROG
1
ATTENTION
If there is a conflict in the timer schedule and one program
overlaps with another, only the parts shown below in gray
will be recorded.
Pattern 1: The program with the lower program number
will be recorded.
10:00
11:00
Program 1
CH10
Program 2
CH40
Pattern 2: The program that is broadcast earlier will be
recorded.
10:00 11:00
Program 1
CH10
Program 2
CH40
Pattern 3: The program that is broadcast earlier will be
recorded, followed by the remaining portion of
the other program.
10:00 11:00
Program 1
CH10
Program 2
2 3
2
5 6
8 9
0
4
OK
12:00
Not recorded
12:00
Not recorded
12:00
CH40
Not recorded
CHECK PROGRAM DATA
5
The PlusCode number you
entered and the matching
Timer-Recording informa-
tion is displayed on the
Program screen. Check to
make sure it's accurate.
To change the stop time,
press STOP +/–.
To timer-record daily or weekly serials, press DAILY
(NUMBER key "8") or WEEKLY (NUMBER key "9").
"DAILY" or "WEEKLY" appears on the Program
screen. Pressing the button again makes each
corresponding display disappear.
If you made a mistake, press
Plus+ screen again and input the correct PlusCode
number.
If the PlusCode number you inputted is incorrect,
"ERROR" may appear on the screen to advise you of
the error. This happens when the PlusCode number is
for a program which has already passed. "ERROR" is
displayed for about 5 seconds and the VCR Plus+
screen reappears.
SET TAPE SPEED
6
Press SP/EP ( ).
RETURN TO NORMAL
SCREEN
7
Press PROG or OK. "PROGRAM COMPLETED" appears
on the screen for about 5 seconds, then normal screen
appears.
ENGAGE TIMER MODE
8
Press ‰ ‰ ‰ ‰ ‰ . The VCR turns off automatically and "‰" is
displayed on the display panel.

IMPORTANT

If you have moved to a different area or if a broadcasting
station's channel number has been changed, the wrong VCR
CH number will be displayed on the VCR Plus+ program
screen in step 5. When this happens, set the correct Guide
Channel number for that station. (
Setup")
NOTES:
To disengage the timer before recording starts, press ‰ ‰ ‰ ‰ ‰ again.
Pressing once more re-engages it.
In case of a power failure after programming, the VCR's memory
backup keeps your selections (if the lithium battery is not
exhausted).
When timer-recording cable channels received through a
Cable Box, be sure to keep the Cable Box set to ON.
29
EN
PROGRAM 1
(VCR PLUS+ 12345678)
START STOP
= 10:00PM
8:00PM
DATE CH
12/24/99 12 SP
THU
PRESS (8=DAILY, 9=WEEKLY
STOP+/– = STOP TIME, SP/EP)
PRESS (OK) TO END
to access the VCR
pg. 30, "VCR Plus+