Stanley SB25PT-05 Manual De Instrucciones página 15

O RIGINAL INSTRU CT I ON
4.2.3 MECHANICAL CURSOR
There are three different mechanical cursor types:
Part number
07271-01100 Used for standard mandrels and 5/32" disposable mandrels
07279-05843 Used for 1/8" disposable mandrels
07279-05845 Used for 3/16" disposable mandrels
If fi tted incorrectly, the cursor will not allow feeding of the fasteners.
TOOL
BARREL
While the cursor will be fi tted the correct way around when the tool is supplied, we recommend that you
check its orientation before fi tting the nose equipment. The sprung loaded, slightly concave, end of the
cursor should point towards the front of the tool as shown in the illustration.
When fi tted the correct way around, the cursor will easily slide out of the barrel when a mandrel is pushed
into its center then pulled back.
To reverse the orientation of the cursor, follow these steps:
• Ensure mandrel removed from tool
• Use 2 fl at bladed screw drivers, unscrew pins retaining tail jaw cover
• Lift cartridge cover (k) away from tool
• Lift tail jaw cartridge (l) away from tool
• Using a spare mandrel with head smaller than 3mm, feed through the small hole of the drive assembly
and push fully through until mandrel is not visible.
• The tail end of the mandrel is now visible from the front of the barrel (f). Pull through fully to remove
cursor from barrel.
16
LOADED END
CURSOR
CURSOR
SPRING
LOADED END
SPRING
NOSE JAWS
TOOL
BARREL
NOSE
JAWS