Tail Jaws; Removing The Cartridge - Stanley SB25PT-05 Manual De Instrucciones

• Select Reload mode and hold trigger for >1second until tool actuates and work light starts to fl ash at
1 second intervals
• Insert the previously assembled mandrel, mandrel follower spring and fasteners into the nose jaws until
the mandrel fully backs onto mandrel stop. There should be a small quantity of fasteners protruding
from the nose jaws.
• Supporting the nose jaws, press and hold the trigger for >1s and the tool will actuate to the home
position. Ensure the mandrel and rivets do not move with the tool
• Close nose jaws and ensure 1 rivet is showing. If incorrect position, refer to Mandrel section (5.4) to
adjust.

5.3 TAIL JAWS

5.3.1

REMOVING THE CARTRIDGE

• Ensure the tool is in home position and mandrel removed from tool.
• Slide forwards the cartridge latch, rotate the cartridge cover upwards to expose the tail jaw cartridge
• Lift cartridge handle and slide cartridge upwards away from the tool
• Fitting the cartridge is the reverse of this procedure
CARTRIDGE
HANDLE
CARTRIDGE
LATCH
5.3.2 REPLACING THE TAIL JAWS
• Ensure tail jaw cartridge removed from tool
• Carefully clamp cartridge body vertically so end cap is facing upwards
• With a 30mm spanner, unscrew end cap from cartridge body
• Remove cartridge body from clamp remove the spring and jaw turret from body.
• The jaws sit in the jaw turret, replace as necessary.
• Assembly is the reverse of this procedure. Ensure the jaws seat correctly when assembling.
CARTRIDGE
ORI GI N A L I N S T RU C T I O N
1.5mm - 3mm
(1/16" - 1/8")
CARTRIDGE
COVER
21