GM 19165847 Guia De Inicio Rapido página 3

12. The square lip on the bottom of the rubber gasket must be
aligned with the pocket. See Figure 12.
FIGURE 12
TUBE BOLT
STAKE POCKET BOLT
13. Snug front and rear stake pocket bolts using a 9/16" wrench
(15mm).
14. Tighten front and rear tube bolts to 20 in*lb.
FIGURE 13
15. Lubricate the channel of the gasket and firmly press the
outer cap (19158750/52) into the gasket and bracket assem-
bly.
16. Tighten stake pocket bolt until rail is firmly mounted to the
truck bed. Do not excessively tighten bolt or inner cap will
not completely close in step 18 to resemble Figure 15.
17. Lubricate channel of the gasket and firmly press the inner
cap (19158749/51) into the gasket and bracket assembly.
Note: The end caps will not fully come together until step
18.
Tubular Side Rails
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION AUTH
FIGURE 14
18. Tighten the end caps together using (4) hi low screws thru
the holes on the inner end cap.
19. Verify the complete installation looks like Figure 15. If the
gap between the inner and outer cap is inconsistent, remove
screws, slightly loosen stake pocket bolt, and repeat steps
17-19.
FIGURE 15
20. Repeat steps 15-19 for the front end cap assembly.
21. Repeat steps 10-20 for the Passenger side.
PART NO.
REV 04AP07
INSTALLATION INSTRUCTIONS
DR
TITLE
Tubular Side Rails
PART NO.
19165847
6200 Grand Pointe Dr., Grand Blanc, MI 48439
HI LOW SCREW
19165847
SHEET
3
SHEET
3 9
OF
9
OF