Model Hc-300 Description, Specifications And Accessories Description; Specifications - RIDGID HC-450 Manual Del Usuario

HC-450/HC-300 Hole Cutting Tools
Figure 9 – Model HC-450 Level Vial
Model HC-300 Description,
Specifications and Accessories
Description
The RIDGID Model HC-300 Hole Cutting Tool is de-
signed to cut holes up to 3" diameter into steel pipe.
The multiple hole size allows the use of Mechanical T's
Hookers ® , Vic-O-Lets™, Weld-O-Let™ and other fittings
for branching unpressurized pipelines.
The HC-300 features a 1 /
date all size of holes up to 3" diameter and standard
hole saw arbors up to 7 / " Hex (
16
motor and gear reduction optimizes the performance
and saw life in the capacity range. A single feed handle
and ON/OFF switch allows for easy operation. The com-
pact two-piece design allows the HC-300 to be used in
tight quarters and difficult-to-reach locations.
NOTE! Mechanical T's, Hookers, and Vic-O-Lets are
registered trademarks of Victaulic Tool Company.
Figure 10 – Model HC-300 Rear View
8
All manuals and user guides at all-guides.com
" capacity chuck to accommo-
2
1 / " chuck size). An integral
2
Figure 11 – Model HC-300 Front View
® ,
Figure 12 – Model HC-300 Isometric
WARNING
Care must be taken to ensure the system is drained and
de-pressurized to prevent serious injury and/or property
damage.

Specifications

Cutting Capacity ............Up to 3" (76mm)
Pipe Mounting
Capacity ........................1
Drill Chuck Capacity ......
Drill Chuck Speed..........360 RPM
Motor Horsepower.........1.2 HP
Current Draw Rating......11 Amps @ 115V
Dimensions
Height ............................12.8" (32.5 cm)
Length ...........................11.9" (30.2 cm)
Width .............................13.2" (33.4 cm)
Ridge Tool Company
The HC-300 is not a hot tapping tool.
1 / " - 8" (30mm-200mm)
4
1 / " - 1 / " (2mm-13mm)
16 2