Sediment Trap; Checking Gas Line Connections - Generac 0060550 Manual De Instrucciones

Fuel Conversion/Gas Connections

Sediment Trap

See C in Figure 5-3. Some local codes require a
sediment trap. Install the recommended sediment trap as
illustrated.
Figure 5-3. Sediment Trap
20

Checking Gas Line Connections

1. Check for leaks by spraying all connection points
2. Check gas pressure at the regulator in the
A
NOTE: Gas pressure can also be tested at the
manometer port on the fuel shut-off valve shown in
B
Figure
C
NOTE: See Owner's Manual or spec sheet for proper
fuel pressure specifications. If the gas pressure is not
000617
within specifications, contact the local gas supplier.
3. Close gas valve when completed.
Figure 5-4. Checking Pressure with Manometer
with a non-corrosive gas leak detection fluid. You
should not see the solution be blown away or form
bubbles.
generator by following these steps.
• Close gas supply valve.
• See Figure 5-4. Remove the top gas pressure
test port from the regulator and install the gas
pressure tester (manometer).
• Open the gas supply valve and verify the
pressure is within the specified values.
5-2.
Owner's Manual for 60 Hz Synergy Generator™
000848