Kit Assembly - Metra 99-6550B Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Secure the radio brackets to the pocket
using the (4) #8 x 3/8" Phillips screws
provided. (Figure A)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Slide the radio into the bracket/pocket
assembly, then secure it to the assembly
using the screws supplied with the radio.
(Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or Axxess.
Test the radio for proper operation.
5. Secure the radio assembly to the dash
using the factory screws.
6. Attach the (7) panel clips provided to the
radio housing trim panel, then reassemble
the dash in reverse order of disassembly
using the 99-6550B radio housing trim
panel to complete the installation.

KIT ASSEMBLY

(Figure A)
(Figure B)
ISO DDIN radio provision
1. Secure the radio brackets to the radio
using the screws supplied with the radio.
(Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or Axxess.
Test the radio for proper operation.
3. Secure the radio assembly to the dash
using the factory screws.
4. Attach the (7) panel clips provided to the
radio housing trim panel, then reassemble
the dash in reverse order of disassembly
using the 99-6550B radio housing trim
panel to complete the installation.
(Figure C)
REV. 10/11/2018 INST99-6550B
3