Description; Description Of The Tool - Hilti POS 150 Guía Rápida

1.2 Explanation of the pictograms and other
information
Symbols
en
Read the Read the
operating operating
instructions instructions
before use. before use.
3R
Do not look Laser
into the radiation
beam.
Avoid
exposing the
eyes to
direct
radiation.
Laser Class
3R
according to
EN 60825‑1:2007.

2 Description

2.1 Use of the product as directed
The tool is designed for measuring distances and direc-
tions, calculating target positions in 3 dimensions and
the values derived from these positions and for laying
out points using given coordinates or values relative to a
control line.
To avoid the risk of injury, use only genuine Hilti ac-
cessories and insert tools.
Observe the information printed in the operating instruc-
tions concerning operation, care and maintenance.
Take the influences of the surrounding area into account.
Do not use the appliance where there is a risk of fire or
explosion.
Modification of the tool is not permissible.
14
All manuals and user guides at all-guides.com
General Return waste
warning material for
recycling.
On the tool
Symbol for Laser Class III / Class 3
On the tool
Notice about the laser exit aperture on the tool.
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.:

2.2 Description of the tool

The POS 150/180 total station can be used to define ob-
jects as dynamic positions within a given space or area.
The tool is equipped with horizontal and vertical circles
with digital graduation, two electronic levels (compensat-
ors), a coaxial electronic distance meter (EDM) incorpor-
ated in the telescope and an electronic processor system
for calculating and saving data.
The built-in target acquisition system allows prisms to be
targeted automatically and their positions tracked even
when they move. The prism's position is determined con-
tinuously and processed in the application on an ongoing
basis. The total station is operated using controller POC
100.
Hilti PROFIS Layout, a PC application provided by Hilti,
can be used to transfer data in both directions between
the total station and a PC, for data processing and
for exporting data to other systems. Data can also be
transferred directly from the controller to a USB data
storage device.