Description - Hilti PMP 34 Manual De Instrucciones

Symbols
Read the Return waste
operating material for
instructions recycling.
en
before use.
>1/4s
Do not look Laser class II according
into the beam. to CFR 21, § 1040
Type identification plate on the tool
Hilti =trademark of Hilti Corp., Schaan, LI Made in Germany
6V=
100mA max.
PMP 34 F

2. Description

2.1 Use of the product as directed
The PMP 34 F is a self-levelling point laser which allows a single person to level, plumb, align and transfer
right angles quickly and accurately. The tool features four coincident laser beams (beams that originate from
the same point). All beams have the same range of 30m (range depends on the brightness of ambient light).
The tool is designed for use mainly in interiors, for determining and checking vertical lines, alignment lines,
and for marking plumb points.
When the tool is used outdoors, care must be taken to ensure that the conditions correspond to working
indoors. For example:
Marking the position of partition walls (at right angles and in the vertical plane).
Aligning components to be installed or sections of a structure in three axes.
Checking and transferring right angles.
Transferring points marked on the floor to the ceiling.
Modification of the tool is not permissible.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
12
Printed: 07.07.2013 | Doc-Nr: PUB / 5071513 / 000 / 00
Disposal of Laser class 2
power tools or in accordance
appliances and
batteries EN 60825-
together with
household
waste is not
permissible.
PMP 34-F
Item.no.
S.No.
Manufact:
1These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out
cover pages. Keep these pages open while studying
the operating instructions.
In these operating instructions, the designation "the
tool" always refers to the PMP 34-F point laser.
with
Location of identification data on the tool
1:2003
The type designation and serial number can be found
on the type plate on the tool. Make a note of this data
in your operating instructions and always refer to it
when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.: