Description - Hilti PR 28 Manual De Instrucciones

Symbols
Read the Return waste
operating material for
instructions recycling.
en
before use.
On the tool
DANGER
LASER RADIATION - AVOID DIRECT
EYE EXPOSURE
675-695nm < 5mW max.
CLASS IIIa LASER PRODUCT
Do not stare into the beam.
Laser warning plates for the USA in accordance with
CFR 21 § 1040 (FDA).
On the tool
3R
Laser warning plate in accordance with IEC825 /
EN60825-1:2003
Type identification plate
Made in Japan
Hilti= registered trademark of the Hilti Corporation, Schaan, LI
DANGER
LASER RADIATION - AVOID DIRECT
EYE EXPOSURE
675-695nm < 5mW max.
CLASS IIIa LASER PRODUCT
EN 60825-1:2003
3R This Laser Product
complies with 21CFR
1040 as applicable
Power: 6.0 V=nom./200 mA
Item No.: 319802
Date.:
PR 28

2. Description

2.1 Use of the product as directed
The tool is designed to be used for determining,
transferring or checking alignment in the horizontal
and inclined planes. Hilti supplies various accessor-
ies which allow the tool to be used with maximum
efficiency.
14
Printed: 07.07.2013 | Doc-Nr: PUB / 5070177 / 000 / 00
PR 28
1 These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out
cover pages. Keep these pages open while studying
the operating instructions.
In these operating instructions, the designation "the
tool" always refers to the PR 28 rotating laser.
Location of identification data on the tool
The type designation and serial number can be found
on the type plate on the tool. Make a note of this data
in your operating instructions and always refer to it
when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
2.2 PR 28 rotating laser
The PR 28 rotating laser projects the horizontal plane
or an inclination of up to 8%.