Calibration And Adjustment; Hilti Calibration Service - Hilti POS 150 Guía Rápida

5.2 Total station
5.2.1 Switching the total station on
NOTE
If the total station cannot be switched on, check that the batteries have been inserted correctly.
If the batteries have been inserted correctly and the total station still cannot be switched on, have it checked by Hilti
Service.
5.2.2 Setting up the total station
When starting up the total station the circular bubble level displayed on the screen must be centered by turning the
tripod footscrews.
NOTE
The total station is equipped with a laser plummet. The laser plummet can be used to set up the total station over a
point marked on the ground or floor.
5.3 Further information and operating instructions
Further information and operating instructions can be found online at:
POS 150 (http://qr.hilti.com/r51292)
POS 180 (http://qr.hilti.com/r51294)

6 Calibration and adjustment

6.1 Hilti Calibration Service

We recommend that the tool is checked by the Hilti Calibration Service at regular intervals in order to verify its reliability
in accordance with standards and legal requirements.
Use can be made of the Hilti Calibration Service at any time, but checking at least once a year is recommended.
The Calibration Service provides confirmation that the tool is in conformance, on the day it is tested, with the
specifications given in the operating instructions.
The tool will be readjusted if deviations from the manufacturer's specification are found.
All manuals and user guides at all-guides.com
Switch the tool on or off.
Laser plummet on / off
Shift focus downwards, rolling.
Confirm the selected display.
en
21