Safety Instructions; Basic Information Concerning Safety - Hilti POS 150 Guía Rápida

IP protection class
Tool (POS 150/180)
Controller (POC 100)
Tripod thread
Tribrach thread
Temperature (POS 150/180, POC 100)
Operating temperature range
Storage temperature range
Dimensions and weights
Dimensions (L x W x H)
Weight
Display
Display
Illumination
Contrast
Dimensions
Control panel
Power supply
AC adapter
Battery
External

4 Safety instructions

4.1 Basic information concerning safety

In addition to the information relevant to safety given
in each of the sections of these operating instructions,
the following points must be strictly observed at all
times.
4.2 Misuse
The tool and its ancillary equipment may present hazards
when used incorrectly by untrained personnel or when
used not as directed.
a) Never use the tool without having received the ap-
propriate instruction on its use or without having
read these operating instructions.
b) Do not render safety devices ineffective and do
not remove information and warning notices.
c) Have the tool repaired only at a Hilti Service Center.
Failure to follow the correct procedures when
opening the tool may cause emission of laser
radiation in excess of class 3R.
All manuals and user guides at all-guides.com
IP 55
IP 67
5/8''
-20...+50°C (-4°F...+122°F)
-30...+70°C (-22°F...+158°F)
POS 150/180
165 mm × 190 mm × 320 mm
(6.5" × 7.5" × 12.6")
5 kg (11 lbs)
POS 150/180
Monochrome, 96 × 49 pixels
Backlit
–
35 × 24 mm
3 buttons + on/off button
for POS 150/180
POA 85
POA 84
POA 88 to 12V
d) Modification of the power tool or tampering with its
e) To avoid the risk of injury, use only genuine Hilti
f)
g) Use only clean, soft cloths for cleaning. If necessary,
h) Keep laser tools out of reach of children.
i)
j)
k) Measurements taken through panes of glass or other
l)
POC 100
105 mm × 210 mm × 70 mm (4.1" ×
8.3" × 2.8")
1.2 kg (2.6 lbs)
POC 100
TFT color touch screen, VGA
640 × 480 pixels
5 levels
Day / night mode selectable
75 × 55 mm
6 buttons + on/off button
for POC 100
POA 81
POA 80
–
parts is not permissible.
accessories and additional equipment.
Never point the tool or its accessories toward
yourself or other persons.
they may be moistened with a little alcohol.
Measurements to plastic foam surfaces, e.g. poly-
styrene foam, to snow or to highly reflective surfaces,
may result in incorrect readings.
Measurements taken to surfaces with low reflectivity
in highly reflective surroundings may be inaccurate.
objects may be inaccurate.
Rapid changes in the conditions under which the
measurement is taken, e.g. persons walking through
the laser beam, may lead to inaccurate results.
en
17