Petzl SEQUOÏA SRT Manual Del Usuario página 4

6
Preparation, adjusting the harness
You can adjust the height of the "attachment bridge"
according to your specifi c needs (usage, techniques,
body morphology. - 3 positions possible). This
adjustment allows a good distribution of pressure over
the leg loops and waist belt.
- Close and use a drop of thread-lock on the screw (obligatory).
- Tighten the screw until the red indicator is no longer visible; continue tightening
to a torque of 3 Nm.
Verify that the 3 straps are correctly positioned in the gated rings (straps should
not be twisted or intertwined).
Do not use the SEQUOIA without the ATTACHMENT BRIDGE.
Adjustment and suspension test
Your harness must be adjusted to fi t snugly to reduce the risk of injury in case
of a fall.
You must move around and hang in the harness (suspension test) from each
attachment point with your equipment to verify that the harness fi ts properly,
provides adequate comfort for the intended use and that it is optimally adjusted.
4
C69AFO SEQUOIA SRT C695010D (010710)
- Open the GATED RINGS by unscrewing the spacer with a
n° 25 male Torx driver.
- Reposition the straps.