Metabo HPT CC 14SF Manual De Instrucciones página 12

English
2. Switch operation.
Fig. 6
WARNING:
3. Cutting operation.
(1) Rotate the cut-off wheel, gently press down the handle, and bring the cut-off wheel
close to the material to be cut.
(2) When the cut-off wheel contacts the material, gently press down the handle further and
start cutting.
(3) When cutting (or designated slotting) is completed, raise the handle and restore it to its
original position.
(4) At the termination of each cutting process, turn OFF the switch to stop rotation and
proceed with the subsequent cutting job.
WARNING:
CAUTION:
● Increased pressure on the handle will not increase the cutting speed.
On the contrary, too much pressure may result in overload of the motor and/or
decreased cutting effi ciency.
12
Pull the trigger to turn on the switch, release it to shut
Hole
it off .
Trigger
After releasing the trigger, make sure the trigger has
Switch
gone all the way back and the switch is turned off .
This will ensure that the power tool cannot be turned on accidentally
or by someone (especially a child) who is not qualifi ed to use the
power tool.
To prevent unauthorized operation of this tool, insert a padlock
through the hole in the switch trigger.
Confi rm that the trigger switch is turned OFF and that the power plug
has been removed from the receptacle, whenever the tool is not in
use.
Always remove the lock-off button from the handle, and store it in a
secure place, after completing the work.