Practical Applications - Metabo HPT CC 14SF Manual De Instrucciones

9. Check the Power Receptacle.
To prevent overheating, accidental stopping or intermittent operation, confi rm that the power
plug fi ts properly in the electrical receptacle and does not fall out after it is inserted.
Repair or replace the receptacle, if it is faulty.
10. Confi rm that the tool's cabtire power cable is not damaged.
Repair or replace the power cord if an inspection of the cabtire cable indicates that it is
damaged.
AFTER CONNECTING THE POWER PLUG TO AN APPROPRIATE AC POWER SOURCE,
CHECK THE OPERATION OF THE TOOL, AS FOLLOWS:
11. Trial Run.
After confi rming that no one is standing in front of it, step away from the front position and
start the power tool and confi rm that no operating abnormalities exist before attempting a
cutting operation.
Trial run periods:
When replacing the cut-off wheel ............Over 3 minutes.
When starting routine work ......................Over 1 minute.
12. Inspect the rotating stability of the cut-off wheel.
For precise cutting, rotate the cut-off wheel and check for defl ection to confi rm that the wheel
is not noticeably unstable; otherwise vibration might occur and cause an accident.

PRACTICAL APPLICATIONS

WARNING:
1. Procedure for fi xing the cutting material (Fig. 4 and 5).
Quick Vise
Place the workpiece material between Vise (A) and Vise (B), raise the clutch and push the
Screw Handle to bring Vise (A) lightly into contact with the workpiece material, as shown
in Fig. 4. Then, turn the clutch down, and securely fi x the workpiece material in position by
turning the Screw Handle. When the cutting job is completed, turn the Screw Handle 2 or 3
times to loosen the vise, and remove the workpiece material, as shown in Fig. 5.
Vise (B)
Vise (A)
Clutch
Screw handle
Never remove or install a workpiece while the cut-off wheel is
rotating, to avoide personal injury.
Workpiece
material
Fig. 4
Vise (B)
Vise (A)
Clutch
Screw handle
Fig. 5
English
Workpiece
material
11