Service And Repairs - Metabo HPT CC 14SF Manual De Instrucciones

English
6. Lubrication.
Lubricate the following sliding surfaces once a month to keep the power tool in good
operating condition for a long time (see Fig. 1 and 2). Use of machine oil is recommended.
Oil supply points:
*Rotary portion of shaft.
*Rotary portion of vise.
*Rotary portion of vise-jaw.
*Quick vise.
7. Cleaning.
Periodically remove chips and other waste material from the surface of the power tool with
a damp, soapy cloth. To avoid a malfunction of the motor, protect it from contact with oil or
water.
CAUTION
In the operation and maintenance of power tools, the safety regulations and standards
prescribed in each country must be observed.

SERVICE AND REPAIRS

All quality power tools will eventually require servicing or replacement of parts because of wear
from normal use. To assure that only authorized replacement parts will be used, and that the
double insulation system will be protected, all service (other than routine maintenance) must be
performed by an AUTHORIZED metabo HPT POWER TOOL REPAIR CENTER, ONLY.
NOTE: Specifi cations are subject to change without any obligation on the part of metabo HPT.
16