Metabo HPT CC 14SF Manual De Instrucciones página 13

4. Cutting at angles (Fig. 7 and 8).
The machine permits cutting at angles of 45° or 60°
When setting at an
angle of 0°
Loosen the two M10 hexagon socket head bolts on the vise (B), then set the working surface
on the vise-jaw at any angles of 0°, 30° or 45° as shown in Fig. 7.
Upon completion of setting, securely tighten the two M10 hexagon socket head bolts, as
shown in Fig. 8.
Vise (B)
M10 hexagon
socket head bolts
Fig. 8
When wide material is to be cut at an angle, it should be fi rmly clamped by fi xing a steel
board like Fig. 9 to the vise (B), as shown in Fig. 9.
5. Moving the stationary vise-jaw (Fig. 10).
The vise jaws open to 8-1/2"
(216 mm) while the vise can
be set in two steps 9-63/64"
(251 mm) and 11-17/64" (286 mm)
Fig. 10
When setting at an
angle of 30°
Fig. 7
8-27/64"
(214 mm)
Flat hd. screw of more than
15/64" × 19/32" (6 mm × 15)
The vise opening is set at the maximum of 8-1/2"
(216 mm) when shipped from the factory.
In case an opening more than 8-1/2" (216 mm) is
required, move the vise-jaw to the position shown by
the chain line, after unscrewing the two bolts.
The maximum opening can be set in two steps 9-63/64"
(251 mm) and 11-17/64" (286 mm).
When the material to be cut is excessively wide, the
vise can be eff ectively used by repositioning the
stationary side of the vise jaws.
English
When setting at an
angle of 45°
1-49/64"
4-23/32" (45 mm)
(120 mm)
15/64"
(6 mm) nut
Two holes 1/4"
(6.5 mm)
More than 15/64"
(6 mm)
Steel
board
Fig. 9
Vise (B)
13